 Are you thinking of tinting your car windows yourself? It is necessary to properly clean the windows in preparation for the installation. Here we talk about the proper installation of window film.
To start your windows with the installation, do not remove any of the backing first and attempt to install it. You will need to lay the film against the outside of the window first and check if the size fully covers the glass. Clean the inside of the window again with the tint solution, but this time leave it wet. Once done, wind down the window by around 2cm and start placing the tinting film at the top. Make sure not to peel it all the way through and just peel the tint at the half way down before spraying the exposed adhesive side with the solution. Leave a 3mm gap to the top edge of the window and place the peeled section against the window. Use the squeegee and lay the top 3 or 4 cm worth of film on the window and squeeze the air bubbles that you find on the film so it remains smooth against the glass. Dry it a little before placing the rest of the tint to make certain that it is properly fixed. When it is finally dry, remove all the backing sheet and continue with the rest of the tint film. Tuck the bottom edge of the film down. To complete the process, before you use the squeegee at the bottom edge flat draw the rubber trim away from the window. If you want to make sure of the right way to install window film, you may want to use the services of a tinting specialist. Since they are expert in window tinting, you can be sure that they get the window tinting job done right know the darkest legal tint North Ipswich. Comments are closed.
|