 Car window tinting can always make your vehicle amazingly beautiful and if you are ready to have one installed, here are some tips on how you can do the cleaning properly before you do the actual installation.
Preparation. If you are going to do car window tinting Ebbw Vale yourself, you will need the following: · Pre-cut window tinting kit · Spray bottle · Cutting knife · Squeegee · Microfibre cloth · Tint solution · Bucket If you are going to tint your car windows yourself, don’t just placed the tinting kit as it is. The end result of this project will depend on how much effort you are placing on the preparation. Do not install the tint on the road where other cars are passing. Better find a good place where the car will not be subjected by dirt and wind like a well-lit garage if possible. Expect a lot of cleaning Clean the inside of your car well and make sure that there are no dust and dirt in the air. Make sure there are no stickers both on the inside and outside of the windows. To remove a sticker and its residue, use a scourer. Clean the rubber seals around the window apply tinting solution using a cloth for the trim. Concentrate on one window at a time when doing the installation. Use a squeegee, microfibre solution and tint solution for the window. Soak the cloth and clean the window thoroughly. This will mostly take time since little particles will just keep on showing up and you have to keep on cleaning the window until the cloth is finally free from those particles. Make sure that all the edges are clean too so lower the window by 5 -10 cm before cleaning it again. Also, remove the excess solution on the window with the use a squeegee. Make sure that both sides of the window are cleaned so that no dirt can transfer on the other side when the window is closed again. Comments are closed.
|